Page 1 of 1

2nd EM-Simulation Meeting in Berlin, Wednesday September 7th

PostPosted: Wed 4. May 2011, 10:20
by Helmar.Waiczies
Dear all,

as an short announcement i’d like to invite you to our second EM-Simulation Meeting in Berlin, Wednesday September 7th, from 15:00-18:00 (but open end as we see fit) just one day prior to the German Chapter of the ISMRM held at the same location ion Berlin. German Chapter of the ISMRM meeting September 8th-9th.

We also planning (as discussed on the last Meeting) a unified simple coil design which everyone is welcome to simulate in their environment and submit the results (anonymously) for further analysis and discussion. We will keep you apprised in this forum about it.

Organizing Comittee:
André Kühne <>
"winter, lukas" <>
"graessl, andreas" <>
"rieger, jan" <>
Tim Herrmann <>
Helmar Waiczies <>

Frank Seifert <>

Tim Herrmann <>
Helmar Waiczies <>

Our program so far:

15.00 Uhr Start with Catering (Snacks and Drinks)

Presentations c. 12min
Frank Seifert - SAR-Standards
Andre Kühne - SAR in Human Models
Andreas Bitz - Application-options of CST MWS for MR
Open Discussion

16.00 Uhr Auswertung der Vergleichsrechnung
Open Discussion

18.30 End
19.00 Meeting at Cafe „Max“ on the MDC Campus
We will have a menu (only beverages are on you)

We will keep you apprised on all changes and looking forward to your feedback !!!



PostPosted: Thu 5. May 2011, 11:53
by Tim.Herrmann
Dear Helmar, dear all, Johannes and I prepared some simulation model of a surface coil with instruction manual.

The Organizing Committee should check this, if they agree we could give this to all participates of the meeting in September to compare the results.

I hope to see the most of you in Montreal.

Best Tim.

PostPosted: Thu 5. May 2011, 16:46
by Helmar.Waiczies
thnx Tim

ill have a look at it asap


PostPosted: Thu 14. Jul 2011, 10:28
by Helmar.Waiczies
Hi All,

we are now ready to proceed. The program for our meeting is ready and also the project "Simulation Comparison". I opened a new topic where u can find
the project discription. Well send a round mail as well but i would like to open the discussion on this topic here inside the forum so everyone can post his/her comments here:

I would like to encourage you all to join the effort.
I think it will be a very interesting and fruitful meeting...